![]() ![]() Restart the saned service to get the new configurations by running the following command in a terminal: sudo service saned restartįor Ubuntu 12.04 only, you will need to tell the computer to start saned automatically when the computer boots up by running the following command in a terminal: sudo update-rc.d saned defaultsĬheck to make sure the saned service is up and running: sudo service saned status Loaded: loaded (/etc/systemd/system/saned.socket enabled vendor preset: enabled)Īctive: active (listening) since Tue 23:58:23 CDT 10min agoĪug 30 23:58:23 pc systemd: Listening on saned incoming socket. This should result in something similar to: ![]() Look for the section that reads: # Access listĪssuming you don't need to control access to the scanner, we will add the line "192.168.0.0/24" (share with everyone on the local network) after "# Access list": # Access listĮxecute at a terminal: sudo systemctl enable saned.socket To do that, we will run the following command from a terminal: sudo nano /etc/sane.d/nf We need to edit the file /etc/sane.d/nf to tell saned who to share with. Look for the section that reads: # Set to yes to start sanedĮdit that so that it reads: # Set to yes to start saned To do that, we will run the following command from a terminal: sudo nano /etc/default/saned We need to edit the file /etc/default/saned to tell the computer to start the saned server. # Environment=SANE_CONFIG_DIR=/etc/sane.d SANE_DEBUG_DLL=255 # To enable under systemd please read README.DebianĮxecute at a terminal: sudo nano input exactly: Step 2: Tell SANE to run as a server (saned)Įxecute at a terminal: sudo nano /etc/systemd/system/saned.socketĪnd input exactly: # Defaults for the saned initscript, from sane-utils See the Scanners page for help setting up and troubleshooting sane. If your scanner is a network attached scanner, you need to get it working on your saned server before sharing it out on the network. If your scanner is a USB scanner do not proceed to step 2 until it is correctly scanning via USB. In order to make network scanning work, you first need to get SANE working with your scanner.Step 1: Set up your scanner on SANE first If you need to add scanner specific information, please do so on the scanner's wiki page. The following step-by-step guide to setting up saned should work for the vast majority of scanners.How to share scanners using SANE daemon (saned) The scanner server (the machine the scanner is local to) is located at 192.168.0.15.This allows other devices to access the scanner, without having to have the scanner plugged directly into the computer.Ī number of assumptions were made regarding this tutorial, that may need to be changed to fit your environment: This tutorial will guide you on how to setup and access a scanner shared over a network.Manually check other configuration files (advanced).Test if the server can reach its own saned on localhost.Troubleshooting sane daemon with upstart.Step 2: Tell SANE to run as a server (saned).Step 1: Set up your scanner on SANE first.How to share scanners using SANE daemon (saned). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |